物理化学学报 >> 1987, Vol. 3 >> Issue (01): 1-3.doi: 10.3866/PKU.WHXB19870101

通讯    下一篇

掺镁氧化铁电极光响应n-p型转换的研究

蔡生民; 陆坦; 周牧易   

  1. 北京大学化学系; 厦门大学化学系
  • 收稿日期:1986-05-24 修回日期:1986-09-20 发布日期:1987-02-15
  • 通讯作者: 蔡生民

THE INVESTIGATION ON INVERSION OF n-TYPE TO p-TYPE PHOTORESPONSES OF MAGNESIUM-DOPED IRON OXIDE ELECTRODE

Cai Shengmin; Lu Tan; Zhou Muoyie   

  1. Department of Chemistry Peking University
    Department of Chemistry Xiamen University
  • Received:1986-05-24 Revised:1986-09-20 Published:1987-02-15
  • Contact: Cai Shengmin

Abstract: Electrodes were prepared with heating commercial pure iron chips buried in Mgo powder and showe dboth n-and p-type photoresponses.The photoresponses were so weak that in fact they were totally buried inthe noise.Hence asignal averager was used. After 1000 cycles'summation the signal to noise ratio was greatly improved and we obtained a wave form series showing the conversion of n-type, p-type photoresponses for the first time.
Fig.1(a): E=0.261V. The absolute peak-to-peak photovoltagevalue (ΔV_(ph)) equals 13.4 mV and shows a typical n-type photoresponse. (b); E=-0.04 V, ΔV_(ph)=1.24 mV, still an -n-type response, but when light is chopped off, the electrode potential reaches its stable value much faster than in (a). (c): When E=-0.076 V, which is only 0.036 V more negative than in (b), in the latter 85% part of illuminating period, electrode potential tends to increase, demonstrating some p-type character. (d): As E=-0.09 V, the magnitude of p-type response almost equals that of n-type. (e): As E=-0.12 V, the main response belongs to p-type, and ΔV_(ph) is only 0.634 mV. This electrode potential is much more positive than the flat band potential of the undoped iron oxide electrode (E_(fb) is about -0.5 V). (f): E=-0.17 V. There is still a small n-type response at the beginning of every illuminating period, and the whole curve appears to be p-type responnse. (g): E=-0.36 V. Typical p-type response appears. ΔV_(ph)=2.05 mV. (h) and (i): E=-0.40 V and -0.45 V. ΔV_(ph) drop to 1.55 mV and 1.05 mV respectively. the above data were reproducible, no retardation of photoresponse was observed when potential was changed.
An XPS surface analysis was performed thereafter on the same electrode. A peak of Mg1S at 1305 eV(BE) is apparent. Huge amount of Mg exists on the surface layer. the relative atomic concentration (s compared with Fe) reaches 15-20 AT%. After Ar~+ etching, the amount of Mg decreases. Fig.2 is the result after 9 minutes′ Ar~+ etching. A possible explanation of these experimental facts based on model of energy band of semiconductors was given.