物理化学学报 >> 2004, Vol. 20 >> Issue (03): 271-274.doi: 10.3866/PKU.WHXB20040311

研究论文 上一篇    下一篇

氧化铝模板上定向纳米碳管的快速生长及超声切短

徐军明;张孝彬;陈飞;李昱;王幼文   

  1. 浙江大学材料物理与微结构研究所; 2硅材料国家重点实验室; 3分析测试中心,杭州　310027
  • 收稿日期:2003-09-22 修回日期:2003-11-11 发布日期:2004-03-15
  • 通讯作者: 张孝彬 E-mail:zhangxb@zju.edu.cn

Rapid Growth of Aligned CNTs on AAO Template and Its Sonication Cutting

Xu Jun-Ming;Zhang Xiao-Bin;Chen Fei;Li Yu;Wang You-Wen   

  1. Department of Materials Science and Engineering; 2State Key Laboratory of Silicon Materials; 3Analysis and Measurement Center, Zhejiang University, Hangzhou　310027
  • Received:2003-09-22 Revised:2003-11-11 Published:2004-03-15
  • Contact: Zhang Xiao-Bin E-mail:zhangxb@zju.edu.cn

PDF (PC)

3403

赞

摘要： 在阳极氧化铝（AAO）模板上电沉积催化剂,快速生长了定向纳米碳管,纳米碳管以顶部生长模式生长.采用了超声的方法来切短露头于AAO模板的纳米碳管,增加纳米碳管膜的定向性.结果显示随着超声时间的增加,纳米碳管的定向性增加.位于纳米碳管膜顶部的催化剂在碳管切短的同时被去除,得到了顶部开口的纳米碳管.解释了纳米碳管被超声切短的机理.

关键词: 定向纳米碳管, 阳板氧化铝（AAO）模板, 超声切短

Abstract: Carbon nanotubes were synthesized on anodic aluminum oxide (AAO) template by chemical vapor deposition catalyzed by electrodeposited cobalt particles in its pores. The growth of the carbon nanotubes on the basis of top-growth model is fast. Sonication cutting process was applied to shorten the outgrown carbon nanotubes to get aligned carbon nanotube film. With the increase of sonicating time, the ordered orientation of carbon nanotubes on the AAO template is improved. Meanwhile, cobalt catalyst on the top of the carbon nanotube is cut off during the sonication. So the end-opened aligned carbon nanotube film is obtained at last. The mechanism of this treatment is also discussed.

Key words: Aligned carbon nanotubes, Anodic aluminum oxide(AAO) template, 　Sonication cutting