物理化学学报 >> 2002, Vol. 18 >> Issue (08): 732-736.doi: 10.3866/PKU.WHXB20020812

研究简报 上一篇    下一篇

二甲基甲酰胺中Y-Mg-Co合金膜的电化学制备

王建朝;何凤荣;刘冠昆;童叶翔   

  1. 中山大学化学与化学工程学院,广州 510275;青海师范大学化学系,西宁 810008
  • 收稿日期:2001-12-10 修回日期:2002-02-04 发布日期:2002-08-15
  • 通讯作者: 刘冠昆 E-mail:ceslgk@zsu.edu.cn

Electrochemical Preparation of Y-Mg-Co Alloy Film from Dimethylformamide Bath

Wang Jian-Chao;He Feng-Rong;Liu Guan-Kun;Tong Ye-Xiang   

  1. School of Chemistry and Chemical Engineering, Sun Yat-Sen University, Guangzhou 510275;Chemisitry Department, Qinghai Normal University, Xi’ning 810008
  • Received:2001-12-10 Revised:2002-02-04 Published:2002-08-15
  • Contact: Liu Guan-Kun E-mail:ceslgk@zsu.edu.cn

摘要: 研究了二甲基甲酰胺(DMF)中Y(Ⅲ) 和Mg(Ⅱ) 及Co(Ⅱ)在Pt电极上的电化学行为.结果表明,Y(Ⅲ)、Mg(Ⅱ)及Co(Ⅱ)在Pt电极上一步不可逆还原为Y(0)、Co(0)和Mg(0).在301 K时,利用循环伏安法分别测定出Mg(ClO4)2-LiClO4-DMF中Mg(Ⅱ)的扩散系数和传递系数为2.95×10-6 cm2•s-1和0.11;CoCl2-LiClO4-DMF中Co(Ⅱ)的扩散系数和传递系数为1.34×10-5 cm2•s-1和0.24;Y(NO3)3-LiClO4-DMF中Y(Ⅲ)的扩散系数和传递系数为1.68×10-5 cm2•s-1和0.10.在铜电极上于-1.50~-3.00 V(vs SCE)下恒电位电沉积,得到黑色、光滑致密、粘附性好的Y-Mg-Co合金膜,其中Y含量为3.88%~58.66%;Mg含量为4.51%~17.52%.

关键词: 钇, 恒电位电沉积, Y-Mg-Co合金, 扩散系数, 传递系数

Abstract: The cyclic voltemmetry method was used to investigate the electrochemical behaviors of Y(Ⅲ),Mg(Ⅱ)and Co(Ⅱ) in Y(NO3)3-LiClO4-DMF,Mg(ClO4)2-LiClO4-DMF and CoCl2-LiClO4-DMF systems on Pt cathode. Experimental results indicate that the electro-reduction of Y(Ⅲ),Mg(Ⅱ)and Co(Ⅱ) to Y、Mg and Co is an one-step irreversible in process. The diffusion coefficient and transfer coefficient of Y(Ⅲ)in Y(NO3)3-LiClO4-DMF system at 301 K are 1.68×10-5 cm2•s-1,0.10; Mg(Ⅱ)in Mg(ClO4)2-LiClO4-DMF system at 301 K are 2.95×10-6 cm2•s-1,0.11; Co(Ⅱ) in CoCl2-LiClO4-DMF system at 301 K are 1.34×10-5 cm2•s-1 and 0.24 respectively. Y-Mg-Co alloy films containing Y from 3.88% to 58.66% and Mg from 4.51% to 17.52% were prepared by potentiostatic electrodeposition on Cu substrate with deposition potential ranging from -1.50 V to -3.00 V(vs SCE).Their surface morphologies were smooth, adhesive, uniform and have metallic luster.

Key words: Yttrium, Potentiostatic electro-deposition, Y-Mg-Co alloy, Diffusion coefficient, Transfer coefficient